FAQs document shredder
The cutting unit should be oiled if cutting performance decreases, a sound develops and after emptying the paper container. Inject the special oil over the entire width of the feed slot onto the blade shafts. Then, press the back arrow key of the black rocker switch to reverse the cutting unit until all paper residues are released. The oiling of cutting units with strip cut improves the cutting performance and avoids squeaking noises resulting from jammed paper residues.
First check if the switching bracket for paper detection is jammed. In this case, you can "unlatch" the paper detection again. It may also be that the switching bracket is broken. The micro-switch that is attached behind the switching bracket could also be defective, or the rocker switch for setting "forward/backward" is defective. In such cases, please contact our customer service.
Disconnect the machine from the power supply and please first check if the switching bracket on the feed slot is jammed. You can "unlock" this easily yourself. If you notice that the cutting unit is stiff, oil the cutting shafts and then restart the machine. If the follow-on control does not work reliably, please contact our customer service.
First, check if the feeding slot above the cutting unit is clogged or blocked. The fault is remedied when the paper is removed.
However, if the fault is accompanied by an unusual noise, broken gear wheels could be the cause. If there are no unusual noises, the cutting rollers might be worn. In such cases, please contact our customer service.
If the engine is overheated, you should let the machine cool down for 15-20 minutes and then try again. Also check for correct positioning of the cutting head above the paper bin. The rocker switch must be "Arrow up". If the machine does not start after checking this step, please contact our customer service.
If a paper jam occurred, pressing the back arrow key of the black rocker switch can reverse the paper. If this does not remove the paper jam, soften the blockage with plenty of special cutting block oil for about 60 minutes. The paper can then be pressed down using a thin piece of cardboard. Please ensure that you machine is switched on while pressing down so that the engine can provide support in removing the blockage. If the paper jam cannot be removed by the described procedure, please contact our customer service.
Please contact our customer service.